You can see BrickPi+ Tutorials and Documentation Here.

BrickPi3 Technical and Design Details Overview The BrickPi3 is used to control Lego Mindstorms robots using the Raspberry Pi. You can connect up to 4 NXT or EV3 motors, and up to 4 NXT or EV3 sensors. You can also connect a Grove I2C device, such as a Dexter Industries PivotPi. You can see a schematic of the BrickPi3...

If the BrickPi3 is not performing as expected, here are some things to try: 1. Is the BrickPi3 green LED on? The green LED should be on when the BrickPi3 is powered on. If the green LED is not on, check the battery connections and make sure the power switch is in the “ON” position. 2. Take the Protective...

Scratch Programming Scratch 1.4 comes pre-installed on all versions of Raspbian and allows you to control your BrickPi3 via a graphical user interface. However the Scratch interpreter which allows communication with the robot is only supported on Raspbian for Robots. Scratch Principles Interaction with the sensors and motors is done via the broadcast block and the sensor block. The...

BrickPi3 – Program in Python Python is the most widely used language with the BrickPi3.  Below are instructions for getting started with the BrickPi and Python.  If you’re using Raspbian for Robots, you can skip the installation, as the Python drivers and examples come fully installed. Installation If you are using Raspbian For Robots, BrickPi3 software is already be...

BrickPi3 Getting Started – Step 4 – Program Your BrickPi Robot We have developed BrickPi3 programming examples for two languages on the Raspberry Pi:  Python and Scratch. We recommend you try out some of our examples, no matter which programming language you want to use.  These programs will be pre-installed on your Raspberry Pi if you are using our free...

BrickPi3 Getting Started – Step 3 – Build Your Robot: Attach LEGO MINDSTORMS (NXT/EV3) Sensors, Motors & TECHNIC Parts The BrickPi3 can be connected to LEGO MINDSTORMS EV3 and NXT sensors, motors and LEGO TECHNIC parts. Below we will walk through each one and explain how it can be used with the BrickPi3. We’ll show you the basics of...

BrickPi3 Getting Started – Step 2 – Connect to the BrickPi3 Connect with a PC, click here Connect with a Mac, click here Set Up Without a Computer (need a monitor, keyboard & mouse) An option that may work for some is to use a monitor, mouse, and keyboard directly with the Raspberry Pi. The BrickPi3 case is designed to...

Step 1 – BrickPi3 Assembly In this step, we will go over the three steps of BrickPi3 Assembly. The BrickPi3 and case will fit the Raspberry Pi B+, Raspberry Pi 2, and Raspberry Pi 3.   1.  Insert the SD Card Before You Begin The SD Card is the hard drive of the BrickPi3 robot. We will insert it into...

Welcome to the BrickPi3 Getting Started guide!   Looking for BrickPi instructions and projects? Click here.   We’ll walk you through getting it set up and started with these step-by-step instructions. We recommend you go through each step below, in the following order:   Assembly: Assemble the Case, Insert the SD Card, Power Up! Connect to the BrickPi   Set...